Skip to main content
All CollectionsHow it Works
Flume Product Specifications
Flume Product Specifications
Joe Fazio avatar
Written by Joe Fazio
Updated over 10 months ago

Flume 2 Water Sensor

Powered by 4 Lithium Metal AA Cell Battery Pack

Size: 2.45” Wide x 3.425” Tall x 5.7” Long

915MHz RF connectivity to Bridge

Works in all ranges to Bridge

IP67 2 foot immersion under water

Automatic Updates

Flume 2 Bridge

USB Power supply, 100-240VAC

Size: 1.88” Wide x 4.36” Tall x 2.3” Long

915MHz RF connectivity to Water Sensor

2.4GHz 802.11 b/g/n wifi connectivity

Operates in 32°F to 158°F

Automatic Updates

FCC STATEMENTS

FCC Compliance Statement:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.‍

Non-modification Warning Statement:

Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.‍

RF Exposure Warning Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.

INDUSTRY CANADA (IC) STATEMENTS

Industry Canada (IC) Warning:

Le present appareil est conforme aux CNR d Industrie Canada applicables aux appareils radio exempts de licence. L exploitation est autorisee aux deux conditions suivantes : (1) appareil ne doit pas produire de brouillage, et (2) l utilisateur de l appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible n compromettre le fonctionnement. Cet équipement doit être installé et utilisé en gardant le radiateur à au moins 20 cm ou plus du corps de la personne. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: 1) This device may not cause interference., 2) This device must accept any interference, including interference that may cause undesired operation of the device. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body.

Did this answer your question?